|
|
发表于 2025-4-29 11:42:47
|
显示全部楼层
我买了你们官方的pan1070模块，用jlink swd烧录一次官方demo程序就再也烧不了
* JLink Info: RESET (pin 15) high, but should be low. Please check target hardware.
* JLink Info: RESET (pin 15) high, but should be low. Please check target hardware.
* JLink Info: RESET (pin 15) high, but should be low. Please check target hardware.
* JLink Info: Found SW-DP with ID 0x0BB11477
* JLink Info: SWD speed too high. Reduced from 2000 kHz to 758 kHz for stability
* JLink Info: DPIDR: 0x0BB11477
* JLink Info: Scanning AP map to find all available APs
* JLink Info: AP[1]: Stopped AP scan as end of AP map has been reached
* JLink Info: AP[0]: AHB-AP (IDR: 0x04770021)
* JLink Info: Iterating through AP map to find AHB-AP to use
* JLink Info: AP[0]: Skipped. Could not read CPUID register
* JLink Info: Found SW-DP with ID 0x0BB11477
* JLink Info: Failed to power up DAP
***JLink Error: Could not find core in Coresight setup
Error: Flash Download failed - Target DLL has been cancelled |
|
发表于 2024-3-26 14:10:51
楼主
